Strait Truck & Tractor Pull

08/15/2025

‼️ SPONSORSHIP OPPORTUNITIES ‼️
Check out the post below ⬇️

08/15/2025

UPDATE : FILLED Thank You!

🚜 Looking for a helper on the scale this year! 🚜

We need someone to help Dave at the scale during the pull — weighing trucks & tractors, jotting down numbers, and being part of the action.
It’s easy, you’ll be right in the middle of everything, and you’ll have the best view in the house!

If you’re up for it (or know someone who might be), send us a message!

08/15/2025

📢 We would like to thank our PLATINUM Level Sponsor to this years event - Napa Robertson Automotive

They are sponsoring our annual Truck and Tractor pull event in Port Hawkesbury on September 6th as a part of the East Coast Pulling Series. We look forward to having them sponsor this event and we thank them for their support & being onboard!

💨 Beast 2.0 Pulling Sled

08/14/2025

🚨 Competitors please read the following rule🚨

Beast 2.0 Pulling Sled

Rules Rules Rules Rules Rules Rules Rules

Here are the updated rules for the 2025 season. Don’t be shy with any questions or if you see any mistakes we can still make changes.

Please see below for the rules we will be following for 2025 season!!! From now on out we will have no more meetings to change rules unless 75% of the pullers in that class come forward wanting a new rule change.

GENERAL RULES
1. Each truck that hooks to the sled must have a fire extinguisher within the drivers reach. With the exception of stock trucks.
2. Drivers must be present 2 hours before the scheduled start time to allow time for registration and tech.
3. Must attend drivers meeting to save confusion during pull.
4. No passengers.
5. No drugs/alcohol.
6. Drive respectfully.
7. No studs/tire chains.
8. All hitches must have a 3"x 3.75” hole and not exceed 26" in height. If a clevis is used it will be measured were the bolt goes through.
9. Any class with hanging weights must not extend past 60" of centerline of the front axle.
10. Hitch must not be attached in front of centerline of rear axle. Hook point can be no closer than 44” from the centre line of the axle.
11. Driveshaft loops are required in every class except stock. They must enclose the universal joint with a minimum of 6” in length. Must be 5/16” steel wall thickness or 3/8” aluminum. If there is more than 3’ between u-joints a support loop is required. Metal or strap material is acceptable.
12. Diesel Classes. Exhaust must exit straight up (Diesel class must have cross bolts in pipe)
13. First puller in class has the option of re-hook.
14. Restart. If the driver makes an attempt to stop before 75’ mark they will be able to make one more attempt.
15. All pulling vehicles with the exception of stock vehicles must have a kill switch that can be activated by the sled operator. The switch must be at least 30” off the ground and near the centre of the vehicle.

GAS CLASSES

STOCK GAS 7300 POUNDS

1. No hanging of weight. Weight must be secured in box.
2. Suspension blocks allowed.
3. Factory duals allowed.

STREET MODIFIED 6200 & 6500 POUNDS

1. Traction bars allowed.
2. Factory duals allowed.
3. Must have driveshaft loops.
4. No dominator carbs/4500 series. Must be a single carburetor on intake. Class will be running a restrictor plate for the season and will be checked at the first event and sealed for the remainder of the season. If repairs need to be done removal will be required at next event for inspection. Restrictor is 1.4” by 4 throttle plate openings or 2.8” opening for a single throttle body.
5.Exhaust must exit behind cab a minimum of 1’
6. Hanging weights allowed.
7. All trucks must retain full sheet metal bodies and all 4 wheels of brakes.
8. Must retain main rear leaf spring and suspension blocks are to be removable.
9. Must wear fire suit and helmet.

MODIFIED GAS 6200 & 6500 POUNDS

1. Must have driveshaft loops.
2. ****Must wear fire suit and helmet.
3. No dual tires permitted.
4. D.O.T. tires only.
5. Must have scatter shield/trans blanket.
6. Only naturally aspirated engines allowed.
7. No large spread bore displacement/Hemi style combustion chamber heads. Measurements will be taken off of exhaust ports.

(Only the Top Truck in the previous class can bump up a class)

DIESEL CLASSES

STOCK DIESEL Max of 9500 POUNDS

1. No hanging weights
2. Any added weight must be in the box. (Securely)
3. Factory duals allowed.
4. No tunes/tuner
5. Blocking of suspension, traction bars and lifts are allowed

*****Cheater Stock Diesel Class Max 9500lbs

1. *Weight to be determined by heaviest truck in class.
2. *Any added weight must be in the box. (Securely)
3. *No hanging weights
4. *Factory duals allowed
5. *Tunes/tuner allowed
6. *Blocking of suspension, traction bars and lifts allowed
7. Trucks in this class are daily driven trucks and must have license, insurance and a valid mvi.

2.6 CLASS 8000 & 8500 POUNDS

1. Must have drive shaft loops.
2. Dual wheels allowed.
3. No nitrous.
4. No propane.
5.**** Turbo size will be checked with a plug. Cover may have to be removed for certain turbos and marked /stamped to save time for next event. Multiple turbos must have atmospheric turbo at 2.6”
6. D.O.T. tires only.
7. Exhaust must exit upward
8. Fuel 1- p7100 13mm or dual cp3
9. Must have helmet and fire suit ( fire proof coveralls)
10. Max wheel base 176”

3.0 DIESEL 8000 POUNDS

1. Must have a break away switch. (Shuts truck off )
2. Must have drive shaft loops.
3. Must have transmission blanket.
4. Must wear fire suit and helmet.
5. Must have a cross in the exhaust (2 3/8 bolts)
6. No nitrous.
7. No propane.
8. Any 2.6 trucks that bump up must have safety equipment.
9. Exhaust must exit upward
10. Engine must be from a factory 1 ton with any chassis combination
11. 3.0 turbo or Atmospheric has to have 3” inlet. Limited to 2 turbo chargers.
12. DOT tires max of 35”
13. Fuel 1- p7100 13mm or max of 2 cp3 pumps

(Only the Top Truck in the previous class can bump up a class)

08/13/2025

We’ll be rolling coal in 24 days! 🚜💨
Give this post a share to your friends 😀

08/09/2025

Another truck pull happening today in Westville. Looking for something to do, check out Beast 2.0 Pulling Sled at Rollin' Coal - Westville Truck Pulls !

Pull line up for Saturday August 9th starting at 3:30pm.
Tech Starts at 1pm
Drivers meeting at 3pm

-Stock Gas Truck 7300lbs
-Street Modified Truck 6200 lbs
-Modified Truck 6200 lbs
-9500lbs Stock Diesel
-Cheater Stock Diesel Truck 9500 lbs
-2.6 Diesel Truck 8000 lbs
-3.0 Diesel Truck 8000 lbs
-Highway Trucks A

Intermission (Food and Drinks)
Show and Shine winners

-Street Modified Truck 6500 lbs
-Modified Truck 6500 lbs
-Cheater Stock Diesel Truck 9500 lbs
-2.6 Diesel Truck 8500 lbs
-3.0 Diesel Truck 8000 lbs
-Highway Truck B
-ECPS vs MTTPA Modified truck Shootout

East Coast Pulling Series
Rollin' Coal - Westville Truck Pulls

07/17/2025

1st Truck & Tractor Pull of the season starts tomorrow in Onslow! 🛻 💨

07/15/2025

🚨FYI🚨
See below ⬇️

Attention!!! Street Modified pullers helmets and fire suits are required for this season.
FR coveralls will pass tech.
Thanks

07/05/2025

🚨 63 DAYS TO GO! 🚨

🔥 Get ready for the STRAIT TRUCK & TRACTOR PULL – ripping back into town on September 6th!

💥 Feel the ground SHAKE as the toughest trucks and tractors battle it out for bragging rights and big pulls!

📍 Mark your calendars.
📣 Tell your crew.
📤SHARE this post.
💪 It’s gonna be LOUD. It’s gonna be WILD. It’s gonna be AWESOME
✏️ More details coming soon!

Let the countdown begin…

05/21/2025

Mark Your Calendars!! 🚜 💨

Registration is now open for our 2025 Points Series. Registration will close June 20th, the cost is $150 per vehicle and driver.

Please send payment to [email protected]

https://docs.google.com/forms/d/1XfNwh_iZ1KjhWF-YyxCkHptRbPdYk4POUsEuAlo6yHg/edit

01/17/2025

Sooooo….. who’s all building a truck for this years East Coast Pulling Series ??? You have 233 days 7 hours 23 minutes til go time
Tag your buds .. Beast 2.0 Pulling Sled

NEW YEAR NEW CLASS! 💨

East Coast King Of The Streets

1-$2500
2-$1500
3-$1000

You must have the safety gear according to the rules for cheater stock. Weights and hitch height as per cheater stock class. Must have valid MVI, insurance, and license that matches the vin for the truck.

Truck can be gas or diesel!

ALL POWER ADDERS ALLOWED❗️
Beast 2.0 Pulling Sled
East Coast Pulling Series

01/13/2025

Lots of clean fill stock piled to build our track extension for this year’s event! The Strait Truck & Tractor Pull Association wants to thank all involved hauling to the site this fall. Steve MacIsaac Trucking, Lowell MacDonald Hardscape, Terry-Angie MacIsaac, NCL, Brilun Construction Ltd, and Norvon Enterprises Limited and anyone else we may have missed - we thank you. NSCC Strait Area Campus for stock piling and working together with us to keep this event a success in the Strait Area 🚜💨